The installation of colored steel tiles provides a guarantee of use for buildings. This product is sturdy and aesthetically pleasing to use, but most people have limited understanding of its corner cutting process. It is mainly to make its edges neat, so that you will find it more uniform when using it.
Portable sandwich panels save a lot of installation time because they are relatively sturdy and do not affect the strength of the building. At the same time, its fire resistance performance adds assurance to the building. It is neatly cut at the edges and corners. In later construction, especially during the alignment phase, it will be very light The multi piece line is arranged at a 45 degree angle, and the cutting efficiency of color steel tiles using this method is significantly multiple times that of single piece cutting.
2. Symmetrically cut two pieces
Using this method, a pair of backup plates with an angle of 90 degrees should be made in advance. The line to be chamfered faces 90 degrees towards the end face along both sides of the backing plate. After aligning the knives, cut off the chamfered part of the sandwich board, and can cut two symmetrical chamfered lines at once. This method is only applicable to symmetric tangent lines. If the workbench allows, 4 or 8 lines can also be cut simultaneously.
3. Corner cutting under special circumstances
The lines should be cut at a 45 degree angle. When the height and bottom size of the colored steel tile are so large that the blade cannot cut, the cutting angle should be changed. The new angle cutting method is to place the line horizontally, rotate the workbench to a certain angle, rotate the blade to a certain angle, adjust the position relationship between the blade and the line, and then cut the angle.
It can be seen that the cutting process of colored steel tiles is well done, and the product will be relatively stable in later use. However, how to handle the edges and corners after cutting is our standard for judging the quality of manufacturers' products. Therefore, we need to pay attention to the cracks during the construction process, otherwise it will affect the overall effect of later use.